Table of Contents
Advertisement
Installation
(Power Unit with KW450 Cab)
1. Place the nylon washers (A) on the inside of the
controller bracket (B).
2.
Install the controller bracket onto the controller
using the 1/4" bolts (C) and flat washers. Tighten
the bolts until the controller pivots with resistance.
C
3.
Install the controller bracket onto the bottom of
the dash plate using 2) 1/4" x 1/2" button head
bolts (C) and 2) 1/4" flange nuts.
4.
Install the gate cable mount bracket (D) on the
back of the right front cab post flange using 2)
#10-32 x 1/2" machine screws and flange nuts.
SPREADER SETUP & INSTALL KITS
A
B
C
D
5. Remove the rear bolt (E) that fastens the right
rear fender panel to the foot platform.
6.
Install the included
1/4" x 1" flange bolt
through the hole,
place one flange of
the cushioned metal
clamp (F) onto the
bolt, and fasten with
a 1/4" flange nut.
7. Route the battery/
controller harness
and the motor/con-
troller harness down
through the seat box
frame, following the hydraulic drive hoses.
8. Route the hoses forward under the foot platform and
through the grommet in the support bracket (G)
under the front of the foot platform.
Setup - 23
E
F
G
Advertisement
Table of Contents
