Table of Contents
Advertisement
4. Install a 3/8 x 1" bolt with a 3/8" flat washer through
the drilled hole and fasten with a 3/8" flat washer
and lock nut. Torque to 245 in-lbs (28 Nm).
5. Repeat steps 1 through 4 to install the right drop
curtain mount onto the right side of the spreader.
6. Install a side belting hanger (R) onto the outside
set of mounting holes on both the right and left
drop curtain mounts (S) using 4) 3/8" x 1" bolts, 8)
3/8" flat washers, and 4) 3/8" lock nuts. Do not
tighten the hardware at this time.
S
SPREADER SETUP & INSTALL KITS
7. Install the rear belting pivot brace (T) and drop
curtain assembly on top of the left and right side
belting hangers (U) using 4) 3/8" x 1" bolts, 8)
3/8" flat washers, & 4) 3/8" lock nuts. Partially
tighten the four bolts to help align the left and
right side belting hangers.
T
U
8.
Tighten the 4) 3/8" bolts (V) that fasten the side
belting hangers to the right and left drop curtain
mount. Torque to 245 in-lbs (28 Nm).
W
R
9.
Finish tightening the 4) 3/8" bolts (W) that fasten
the rear belting pivot brace to the side belting
hangers. Torque to 245 in-lbs (28 Nm).
Setup - 29
V
Advertisement
Table of Contents
