Table of Contents
Advertisement
4. Install the spreader control box bracket onto
the control box mount using 2) #10-32 x 1/2"
machine screws and #10-32 flange nuts.
5. Fully extend the control box mount arm and tighten
the knobs to clamp the control box mount in place.
6. Route the gate cable along the back of the power
unit seat box and up the inside of the right rollbar.
Install the gate control cable (C) and handle onto
the control box mount.
C
7.
Use Velcro ties to fasten the gate cable to the roll
bar 2-3" above the power unit fender and to the
power unit seat box.
8.
If gate cable is already mounted to the spreader,
Pull the gate cable handle out
skip to step # 12.
3" and determine the length of cable needed to
reach the gate body. NOTE: before cutting the
cable to length, check to ensure that there is
enough slack in the cable to allow the control
cable to slide freely in the cable housing.
SPREADER SETUP & INSTALL KITS
9. Cut off the cable at the desired length and then
push the gate cable handle back into the cable
housing. Slide the brass cable fitting onto the
gate cable and thread onto the cable housing.
10. Install the cable fitting onto the gate body (D) as
shown.
11.
Insert the cable end into
the gate slide (E) and
through the hole in the bolt.
Ensure the gate slide is in
the closed position and
tighten the bolt to secure
the gate cable.
12. Connect the battery/
controller wire harness
to the positive and nega-
tive wires connected to
the power unit battery.
Connect the harness to
the battery lead on the
spreader controller.
13. Connect the motor/controller wire harness to the
motor lead on the spreader controller. Connect the
harness to the power cord on the spreader. NOTE:
if the power unit is equipped with a 3 point hitch,
route the harness down between the power unit
seat box and the pivot shaft on the 3 point hitch
before connecting to the spreader's power cord.
14. Use Velcro ties to fasten both wire harnesses to
the arm of the control box mount just behind the
controller and also to fasten the harnesses
together, but not to the control box arm, about
halfway back to the roll bar.
Setup - 15
D
D
E
E
Advertisement
Table of Contents
