Table of Contents
Advertisement
SS575 Install 4500 Kit
Document Number
09.700169
Before making repairs or adjustments set the parking
brake, turn off engine, and remove ignition key.
Always disconnect the negative battery cable from the
battery when working with electrical components. Always
work in a manner that does not put safety at risk!
Installation Time (estimated)
Tools Required:
3/8" wrench
5/32" hex wrench*
1. Disconnect the negative battery cable from the
power unit's battery.
2. Open the toolbox lid and remove the left (A) and
right (B) toolbox liner panels.
3.
Place the wire adapter harness in the power
units seat box area. Route the ground wire with
the ring terminal along the main harness and
connect to the ground stud (C). Use zip ties (D)
to fasten the wire to the main harness.
C
D
SPREADER SETUP & INSTALL KITS
Kit Number / Part Number
70.8129
7/16" wrench*
Phillips screwdriver*
B
A
D
Model
SS575
Safety glasses must be worn during installation.
Ear (hearing) protection must be worn when us-
Installation Notes: Right and left hand orienta-
tion referred to in these instructions is determined
as if sitting on the tractor seat, facing forwards.
1 hour
9/16" socket*
side cut pliers
4. Route the red and white wires with terminals into
the toolbox area.
5. Use a needle nose pliers to remove the green
plugs (E) from positions A1 and A3 (F - red high-
lighted positions) on the rear fuse panel.
E
NOTE: Both the picture
and the sketch are shown
from the rear of the fuse
panel inside the toolbox.
6.
Install the terminal on the red wire into position
A1 in the fuse panel. Install the terminal on the
white wire into position A3 in the fuse panel.
NOTE: the terminal can only be installed one
way. Orient the terminal with the hole pointing up
and insert into the fuse panel. The terminal needs
to snap into place. If necessary, use a needle
nose pliers to push the terminal in, being careful
not to damage the wire insulation. Double check
the connection by tugging gently on the wire with
your hand.
7. Reinstall the left and right toolbox liner panels.
Setup - 19
Serial Number Range
All Units
3/4" socket
*Not necessary for all setup configurations.
AA A
1
2
3
4
5
6
7
8
9
10
Back View Of Rear Fuse Block
impact driver
B C D
C
EX
30
86
F
NC
NO
EX
87a
85
87
C
EX
30
86
NC
EX
NO
87a
87
85
C
EX
30
86
NC
EX
NO
87a
85
87
C
EX
30
86
NC
EX
NO
87a
85
87
C
EX
30
86
NC
EX
NO
87a
85
87
Advertisement
Table of Contents
