Table of Contents
Advertisement
anchor bracket using a Velcro tie.
14.
If gate cable is already mounted to the spreader,
skip to step # 18.)
3" and determine the length of cable needed to
reach the gate body. NOTE: before cutting the
cable to length, check to ensure that there is
enough slack in the cable to allow the control
cable to slide freely in the cable housing.
15. Cut off the cable at the desired length and then
push the gate cable handle back into the cable
housing. Slide the brass cable fitting onto the
gate cable and thread onto the cable housing.
16. Install the cable fitting onto the gate body (H) as
shown.
H
17.
Insert the cable end into
the gate slide (I) and
through the hole in the bolt.
Ensure the gate slide is in
the closed position and
tighten the bolt to secure
the gate cable.
18. Install the circuit breaker
into the fuse holder
of the positive wire as
shown above.
19. Reinstall the power
unit's tunnel cover.
Installation is complete.
SPREADER SETUP & INSTALL KITS
Pull the gate cable handle out
H
Fuse Holder
Vibrator Installation (Power Unit without Cab)
1. Install the switch on the controller bracket as
directed by the vibrator kit instructions.
2. Install the vibrator unit on the spreader hopper
as directed by the vibrator kit instructions.
3. Connect the vibrator wire harness to the switch
and route wire harness along the same path as
the spreader wire harnesses.
4. Connect the wire harness plug to the plug on the
vibrator unit.
5. Connect the positive wire of the battery harness
to the positive terminal of the power unit battery.
6. Connect the negative wire of the battery harness
to the negative terminal of the power unit battery.
7. Use zip ties to fasten the vibrator wire harness
to the control box mount arm, the power unit roll
bar, and the power unit seat box.
Vibrator Installation
(Power Unit with KW350 Cab)
1. Install the switch on the controller bracket as
directed by the vibrator kit instructions.
2. Install the vibrator unit on the spreader hopper
as directed by the vibrator kit instructions.
3. Connect the vibrator wire harness to the switch
and route wire harness along the same path as
the spreader wire harnesses. Install the vibrator
wire harness into the cushioned metal clamps
under the power unit foot plate that contain the
spreader wire harnesses.
I
4. Connect the wire harness plug to the plug on the
vibrator unit.
5. Route the vibrator battery harness up between the
seat box and the hitch frame upper anchor bracket
and through the cutout for the rear hydraulic motor.
I
6. Connect the positive wire of the battery harness
to the positive terminal of the power unit battery.
7. Connect the negative wire of the battery harness
to the negative terminal of the power unit battery.
8. Use zip ties to fasten the vibrator wire harness
to the cab post inside the cab and to the hitch
frame upper anchor bracket.
Setup - 18
Advertisement
Table of Contents
