Venture Products Ventrac SS575 Operator's Manual & Parts Drawings page 28

3. Place the rear belting pivot brace (D) onto the
underside of the rear belting mount. Install 2)
pivot tube clamps (E) onto the rear belting mount
using 2) 1/4" x 3/4" bolts (F), 4) 1/4" flat washers,
and 2) 1/4" lock nuts at the top of the rear belting
mount and 2) 1/4" x 1" bolts (G), 4) 1/4" flat wash-
ers, and 2) 1/4" lock nuts at the two center holes
in the rear belting mount and drop curtain. Torque
to 75 in-lbs (8.5 Nm).
D
E
G
SPREADER SETUP & INSTALL KITS
F
Installation on SS575 Spreader
1. Remove the 2) 3/8" bolts from the left side of the
spreader frame and discard.
2. Install the left drop curtain mount (Q) onto the
spreader frame with the longer slot toward the
top. Fasten with 2) 3/8" x 1" bolts and 2) 3/8" flat
washers. Keep the edge of the curtain mount
parallel with the edge of the spreader frame and
torque the bolts to 245 in-lbs (28 Nm).
3. Using the long slot in the curtain frame as a
E location guide, drill a 13/32" hole through the
spreader frame. Remove any burrs and metal
shavings and use black paint to touch up the
exposed metal.
Setup - 28
Q