Table of Contents
Advertisement
SS575 Install 4100/4200 Kit
Document Number
09.700131
Before making repairs or adjustments set the parking
brake, turn off engine, and remove ignition key.
Always disconnect the negative battery cable from the
battery when working with electrical components. Always
work in a manner that does not put safety at risk!
Installation Time (estimated)
Tools Required:
3/8" wrench
impact driver
7/32" drill bit*
*Not necessary for all setup configurations.
1. Disconnect the negative battery cable from the
power unit's battery.
2. Remove the nut and bolt from the positive and
negative battery cable clamps and replace them
with 5/16" x 1-1/2" bolts and nuts. Tighten the
positive clamp onto the positive battery terminal.
3. Install the fused positive wire onto the positive
cable clamp bolt and fasten with a 5/16" nut.
4. Install the negative cable onto the negative terminal
and tighten. Install the negative wire onto the nega-
tive cable clamp bolt and fasten with a 5/16" nut.
5. Using a side cut pliers, cut both battery terminal
covers at the locations shown and install onto
the battery terminals.
SPREADER SETUP & INSTALL KITS
Kit Number / Part Number
70.8113
7/16" wrench*
Cut Here
Model
SS575
Safety glasses must be worn during installation.
Ear (hearing) protection must be worn when
Installation Notes: Right and left hand orienta-
tion referred to in these instructions is determined
as if sitting on the tractor seat, facing forwards.
1 hour
1/2" wrench
drill*
phillips screwdriver
6. Install the spreader hitch onto the spreader using
4) 1/2" x 1-1/4" bolts and 4) 1/2" flat washers. Use
Loctite 242 or equivalent thread locker on bolts.
Torque to 45 ft-lbs (61 Nm).
7. Fasten the spreader's power cord to the hitch
frame at two places using zip ties.
Setup - 13
Serial Number Range
All Units
using air or power tools.
9/16" socket*
3/4" socket
side cut pliers
Advertisement
Table of Contents
