Sargent ASSA ABLOY PR100 Installation Instructions Manual page 13

PR100 Cylindrical Lock
15 Install or Replace Batteries, Battery Keeper, and Cover
1. To install the batteries, first remove the battery cover using the security tool provided (Fig. 15C).
2. Unscrew the bottom screw of the battery keeper and remove the battery keeper, being careful not to break
the tabs at top holding it in place. (Fig.15A)
3. Place (6) "AA" batteries in the compartment, being careful to align polarity properly (Fig. 15B)
4. Replace battery keeper being careful to engage tabs at top to hold it in place. (Fig. 15A)
5. Attach battery cover to inside escutcheon making sure to line up tabs with retaining slots in battery cover.
6. Secure with the security screw using tool (Fig. 15C).
NOTE: Ensure the tamper switch activator does not fall out of the cover during assembly Fig. 15D. A tamper
event message will be sent to the EAC panel if tamper is enabled.
Fig. 15A
Tabs
Fig. 15B
Retaining
slots
Tamper switch
activator
Fig. 15C
Security Tool
1-800-810-WIRE • www.sargentlock.com • A8079D
Fig. 15D
13