Advertisement
PR100 Cylindrical Lock
11 Escutcheon Wire Connections
Images are shown without gasket. If gasket
is necessary, refer to Step #10.
Before the controller is
attached to the door:
1. Attach the reader assembly
ribbon cable into the back
of the controller assembly
(side that faces towards the door
when mounted) Fig. 11.
12 Lock Wire Connections
1. Connect the cable from the cylindrical
lock to the bottom of the controller
assembly (TB1, Fig. 12 Detail).
2. Connect the DPS connector to the 3-pin
harness (TB2, Fig. 12).
Reader
Cable
Outside
Escutcheon
1-800-810-WIRE • www.sargentlock.com • A8079D
Inside of Door
Controller
Escutcheon
Fig. 11
Inside of Door
Reader
Cable
TB2
Door Position
Switch (DPS)
Inside
Escutcheon
(Back)
Fig. 12
Inside
(Back)
TB1
11
Advertisement
