Environmental Conditions; Operating Material; Emissions; Assembly 3.1 Extent Of Supply - Jet BD-11G Operating Manual

Environmental conditions

Temperature
Humidity

Operating material

Feed gear
Bright steel parts and lubricating
i l
Change gears

2.1 Emissions

The level of noise emitted by the lathe is less than 70 dB(A).
INFORMATION
If the lathe is installed in an area where various machines are in operation, the acoustic influ-
ence (immission) on the operator of the lathe may exceed the legally permitted peak value in the
workplace.
We recommend the use of soundproofing and ear protection.
3. Assembly
INFORMATION
The lathe comes pre-assembled.
3.1 Extent of supply
When the machine is delivered, check immediately that the lathe has not been damaged during
shipping and that all components are included. Also check that no fastening screws have come loose.
Compare the parts supplied with the information on the packaging list.

3.2 Transport

WARNING!
Machine parts falling off forklift trucks or other transport vehicles could cause very seri- ous
or even fatal injuries. Follow the instructions and information on the transport case:
Centres of gravity
Suspension points
Weights
Means of transport to be used
Prescribed shipping position
WARNING!
Use of unstable lifting and load-suspension gear that might break under load can cause very serious
injuries or even death.
Check that the lifting and load suspension gear has sufficient load capacity and that it is in perfect
condition. Observe the rules for preventing accidents.
Hold the loads properly.
Never walk under suspended loads!
BD-11G
5 - 35 °C
25 - 80 %
BD-11G
Mobilgear 627 or equivalent oil
Non-corrosive lubricating oil
Chain oil (spray box)
16