Prohibition, Warning And Mandatory Labels; Safety Check; Individual Protection Gear - Jet BD-11G Operating Manual

CAUTION!
Only operate the lathe using this key.

1.6.4 Prohibition, warning and mandatory labels

INFORMATION
All warning labels must be legible. Check them regularly.

1.7 Safety check

Check the lathe at least once per shift. Inform the person responsible immediately of any dam- age,
defect or change in operating function.
Check all safety devices
at the beginning of each shift (with the machine stopped)
once a week (with the machine in operation)
after every maintenance and repair operation
Check that prohibition, warning and information labels and the markings on the lathe
can be identified (if not, clean them)
are complete
INFORMATION
Use the following table for organizing the checks.
General check
Equipment
Protective
cover,
Labels, markings
Date:
Run test
Equipment
EMERGENCY STOP
button
Lathe chuck key
Date:

1.8 Individual protection gear

Check
Fitted, firmly bolted and not damaged
Installed and legible
Checked by (signature):
Check
When the EMERGENCY STOP button is activated, the
lathe should be switched off.
Once the chuck key has been released, it should be
automati- cally pressed out of the lathe chuck.
Checked by (signature):
12
OK
OK