Reset; Factory Reset; Reset Via The Settings Menu; Reset Via The Power Button - Minelab MANTICORE Instruction Manual

Reset

For information on how to reset a single Search Mode only,
see "Reset a Search Mode" on page

FACTORY RESET

Factory Reset can be done in two ways; via the Settings
Menu, or via the Power Button�
Factory Reset will return all detector settings to their
default state, including Search Modes�

Reset Via the Settings Menu

1. Turn the Detector On ( )�
2. Navigate to Reset:
Settings > General Settings >
3. Press to display the Reset confirmation screen�

4. A warning message will be displayed — if you are
sure you want to reset the detector, confirm again by
pressing the Right Soft Key (
There will be a confirmation tone and message when
Reset is complete�

Reset Via the Power Button

1. Turn the Detector Off ( )�
2. Press‑and‑hold the Power button ( ) until there is
a confirmation tone and 'Factory Reset Complete'
message�
3. Release the button�
CONTENTS
60�
Reset
Confirm)�
36