Manual Ground Balance; Tracking Ground Balance; Turn Tracking Ground Balance On/Off; Manual Ground Balance Procedure - Minelab MANTICORE Instruction Manual

Ground Balance

MANUAL GROUND BALANCE

Ground Balance can be manually adjusted until the
minimum amount of ground signal is present�

Manual Ground Balance Procedure

1. Navigate to Ground Balance:
Settings > Ground Balance
2. Raise and lower the Coil repeatedly over a clear patch of
soil that does not contain any targets�
3. Listen to the audio response to interpret the result
of the Ground Balance; a low tone indicates that you
should increase the Ground Balance value and a high
tone indicates that you should decrease it�
4. Press / to manually change the Ground Balance value
until the minimum amount of ground signal is heard�
NOTE: Tracking Ground Balance will be automatically
turned Off if Ground Balance is adjusted manually�
CONTENTS
(Continued)
56

TRACKING GROUND BALANCE

Tracking Ground Balance continuously monitors the ground
signal and adjusts the Ground Balance setting to ensure it
is always set correctly� This is useful in locations where the
ground signals are constantly changing, so you don't have
to continually perform a Ground Balance�
Tracking Ground Balance is the default and recommended
Ground Balance method for Beach Surf & Seawater
mode and Goldfield General mode� It effectively manages
the constantly changing conditions in salt‑water and
mineralised goldfield soils�

Turn Tracking Ground Balance On/Off

1. Navigate to Ground Balance:
Settings > Ground Balance
2. Press the Right Soft Key (
Ground Balance On/Off�
When Tracking is On, the Tracking icon (
in the Status Bar�
NOTE: Tracking Ground Balance will be automatically
turned Off if Ground Balance is adjusted manually�
Ground Balance
58 42 0
Tracking) to turn Tracking
) is displayed
The Ground Balance value
will update automatically
as it tracks to changing
ground conditions�