Wireless Software Update Error; Large Metal Overload; Internal Error - Minelab MANTICORE Instruction Manual

Errors
(Continued)

WIRELESS SOFTWARE UPDATE ERROR

Wireless Software
Update Error
Connect to Minelab Update
Utility and try again.
A Wireless Software Update Error can occur when the
wireless audio component of a detector software update
fails� Like the Software Update Failed Error, this may occur
if the software update is interrupted� The detector may
function in this instance, but Wireless audio may not work�
To resolve the Error, try updating the detector software
again, ensuring that the magnetic USB cable remains
securely connected until the update completes�

INTERNAL ERROR

To resolve an Internal Error, try the following:
1. Restart the detector�
2. Perform a Factory Reset — see
Reset" (page 36)�
If the Error persists, contact a Minelab Authorised
Service Centre�
CONTENTS
The Wireless Software
Update Error message�
Press ( Back) to resume
normal detector operation,
but without wireless audio�
"Factory

LARGE METAL OVERLOAD

MANTICORE will display the Large Metal Overload icon if
a very large metal mass is detected close to the coil� It is
designed to prevent the battery from becoming flat in the
event that the detector was not turned Off before storing
in a vehicle, metal storage locker, etc�
The Large Metal Overload icon will flash in the Status Bar
for up to 5 minutes�
To resolve the condition, move the detector away from the
overload source� The detector will resume normal operation
immediately once the electronics are no longer overloading�
If the overload condition remains uninterrupted for
5 minutes, the Large Metal Overload message will be
displayed for 5 seconds before the detector shuts‑down
automatically�
Large Metal
Overload
Shutting Down...
70
The Large Metal Overload message�
The detector will shut‑down
automatically 5 seconds after
displaying this message�