Locate A Target Manually - Minelab MANTICORE Instruction Manual

Pinpointing
(Continued)

LOCATE A TARGET MANUALLY

It is possible to locate a target successfully without using
Pinpoint Mode, however this requires practice� This method
may be required when a desirable target is surrounded
by trash�
1. Sweep the Coil slowly across the target location
keeping the Coil parallel to the ground�
2. Locate the centre of the target by listening for the
loudest target signal response�
3. Make a mental note of the position, or mark a line on
the soil with your shoe or a digging tool�
4. Move to one side so that you can pass the Coil over the
target at right angles to your initial direction�
5. Repeat steps 1 and 3 from your new position� The target
is located where the two imaginary lines cross�
1–3
Make a line where the
strongest signal is heard�
4–5
Stand at right‑angles to your
initial position and repeat�
The intersection of the two
lines marks the exact location
of the target�
CONTENTS
Beep! Beep!
Beep! Beep!
31