僅 Replacing Rear Turn Signal Lamp (Bulb Type) - Kia Sorento 2023 Owner's Manual

Maintenance
Pull the bulb out of the socket.
9. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
10.Install the socket in the assembly by
aligning the tabs on the socket with
the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
11.Install the rear combination lamp
assembly to the body of the vehicle.
12.Install the service cover.
Replacing rear turn signal lamp
(Bulb type)
OMQ4070060
1. Turn off vehicle and disconnect the
negative terminal from the battery.
2. Open the liftgate.
3. Open the service cover.
4. Loosen the light assembly retaining
screws with a cross-tip screw driver.
8 62
OMQ4070061
5. Remove the rear combination lamp
assembly from the body of the vehi-
cle.
6. Disconnect the rear combination lamp
connector.
7. Remove the socket from the assembly
by turning the socket counterclock-
wise until the tabs on the socket align
with the slots on the assembly.
OMQ4070055
8. Remove the bulb from the socket by
pressing it in and rotating it counter-
clockwise until the tabs on the bulb
align with the slots in the socket.
Pull the bulb out of the socket.
9. Insert a new bulb by inserting it into
the socket and rotating it until it locks
into place.
Light bulbs