Kia Sorento 2023 Owner's Manual page 191

Features of your vehicle
1) Programming Preparation
1. When programming a garage door
opener, it is advised to park the vehi-
cle outside of the garage.
2. It is recommended that a new battery
be placed in the hand-held transmit-
ter of the device being programmed
to HomeLink for quicker training and
accurate transmission of the radio-
frequency signal.
3. Press the ENGINE START/STOP but-
ton to the ACC (Accessory) position
for programming of HomeLink.
OMQ4041545N
2) Programming a New Home-
Link씾 Button
1. Press and release the HomeLink but-
ton (1), (2) or (3), you would like to
program. The HomeLink indicator
light (7) will flash orange slowly (if not,
perform the steps of "Erasing Home-
Link Buttons" section, and start over).
OMQ4041546N
2. Position the garage door opener
remote 2 - 8 cm (1 - 3 inches) away
from the HomeLink buttons.
OMQ4041547N
3. While the HomeLink indicator light (7)
is flashing orange, press and hold the
hand-held remote button. Continue
pressing the hand-held remote button
until the HomeLink indicator light (7)
light changes from orange to green.
You may now release the hand-held
remote button.
4. Wait until your garage door comes to
a complete stop, regardless of posi-
tion, before proceeding to the next
steps.
5. Press and release the HomeLink but-
ton you are programming and
observe the indicator light.
Mirrors
5
5 61