Maintenance
10.Install the socket in the assembly by
aligning the tabs on the socket with
the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
11.Install the rear combination lamp
assembly to the body of the vehicle.
12.Install the service cover.
Replacing rear turn signal lamp,
stop and taillamp, rear side
marker lamp (LED type)
OMQ4AH070059
If the stop and taillamp (1), rear turn sig-
nal lamp (2), taillamp (3), and rear side
marker lamp (4) do not operate, have
your vehicle checked by an authorized
Kia dealer.
The LED lamp cannot be replaced as a
single unit because it is an integrated
unit. The LED lamp has to be replaced
with the unit.
A skilled technician should check or
repair the stop and taillamp (LED), for it
may damage related parts of the vehicle.
Replacing reversing lamp (bulb
type)
1. Turn off vehicle and disconnect the
negative terminal from the battery.
2. Remove the plastic tabs with a flat-tip
screw driver.
OMQ4070105L
3. Loosen the plastic retaining screws
and remove the under panel cover.
4. Disconnect the rear reversing lamp
connector (A).
OMQ4070107L
Light bulbs
8
8
63