Table of Contents
Advertisement
Preparatory measures before (initial) start-up
Note
The training device starts only with SD card inserted. If it is not loaded, after
turning on all LEDs will light up.
3.5 Entering the Device Code for Remote Control
For the operation of the remote control, 2 batteries AAA size are needed. Please note that
after each battery change the device code of the remote control must be re-entered.
Push and hold the "SET" button
Press the "TV" - button until the red LED lights up permanently.
Release both buttons again
Enter "1 6 0".
Following this the red LED goes out and the remote control is ready for operation.
Fig. 14: Remote Control – Installing the Batteries
14 / 24
23560 HeartSave AED Trainer / GB / B02
Battery
METRAX GmbH
Advertisement
Table of Contents
