Signalling Of Operational Statuses - 2N LTE Verso Configuration Manual

4. Signalling of Operational Statuses

2N LTE intercom generates sounds to signal switching and changes of operational statuses.
Each status change is assigned a different type of tone. See the table below for the list of signals.

Note
• Signalling of some of the above mentioned statuses can be modified; refer to the
User Sounds subsection.
Tone Meaning
User activated
This tone signals entering of the user activation code. The activation code
is used for user (user's position) activation. Refer to the Users subsection
for the activation code settings.
User deactivated
This tone signals entering of the user deactivation code. The deactivation
code is used for user (user's position) deactivation. A deactivated user
may not be called but the call can, if necessary, be forwarded to a deputy
if defined. Refer to the Users subsection for the deactivation code settings.
Profile activated
This tone signals profile activation. This function helps enable alerting of a
user group in an office, for example. Refer to the Profile subsection for the
activation code settings.
Profile deactivated
This tone signals profile deactivation. This function helps, for example,
disable alerting of a user group in an office and routing calls either to a
pre-defined phone number (porter's lodge, e.g.) or user mobile phones.
Refer to the Profile subsection for the deactivation code settings.
Call prolongation confirmation signalling
Calls are time-limited in 2N LTE intercoms for security reasons
(protection against blocking). Refer to the Miscellaneous subsection for
details.
2N® LTE Verso Configuration Manual
16 / 224