Table of Contents
Advertisement
•
IP Address 1–4 – set up to 4 authorised IP addresses from which you can log in to the
RTSP server. If none of the four fields is completed, any IP address can be used for login.
•
QoS DSCP Value – set the audio/video RTP packet priority in the network. The set value is
sent in the TOS (Type of Service) field in the IP packet header.
•
UDP Unicast Enabled – enable audio/video stream sending via the RTP/UDP. If this mode
is off, the audio/video stream data are sent via the RTP/RTSP only.
•
Maximum Video Packet Size – set the maximum size of the video packets to be sent via
the RTP/UDP.
•
Starting RTP Port – set the starting local RTP port in the range of the length of 60 ports to
be used for audio and video transmissions. The default value is 4800 (i.e. the used range is
4800–4859).
•
Jitter Compenstantion – set the buffer capacity for jitter compensation in audio packet
transmissions. A higher capacity improves the transmission resistance at the cost of a
greater sound delay.
Tip
•
FAQ: VLC Player – How to watch a video from 2N IP intercom RTSP server
•
FAQ:
VLC Player – How to record video from 2N IP intercom
2N® LTE Verso Configuration Manual
147 / 224
Advertisement
Table of Contents
