Related Manuals for 2N Lift1 Compact
Summary of Contents for 2N Lift1 Compact
- Page 1 ® Lift1 Compact Comunicator for Lifts Brief Manual Issue 2, Version 1.2 www.2n.cz...
-
Page 2: Extending Modules
Description ® Lift1 Compact (hereinafter referred to as Lift1) is a robust, metal-encased audio unit equipped with an ALARM button of the prescribed size by default. In buttonless versions, an external button is connected as necessary. The audio unit is equipped with illuminated pictograms to signal the connection state and an induction loop for deaf people. -
Page 3: Mounting Preparation
Before you start Installation Conditions Lift1 is not intended for outdoor applications. As the product is connected to a telephone line and may thus produce life-endangering voltage, follow the safety precautions – refer to Safety Precautions. Never connect Lift1 to a line in parallel with another terminal device. ... -
Page 4: Electrical Installation
Electrical Installation Terminals Terminals on the rear side The ALARM1 terminal block helps activate alarm calls. The alarm button on the cover of button versions remains active even if an external button is connected or voltage control is used for activation. The ALARM2 terminal block can be used for alarm to different set of numbers, especially with... -
Page 5: Telephone Line Connection
Set the jumper to ON to activate the recovery mode for FW upgrade whenever a problem occurs with the RECOVERY ® Lift1 – 2N Service Tool connection. MODE PROGRAMMING for 2N® USB programming tool for configuration, CONNECTOR ®... - Page 6 If you cannot access the cabin wall from the outside, use the screws under the pictogram glass: Insert the hex key wrench (included in the package) in the hole on the product bottom edge and turn it left (about 10 times) until it puts up resistance. ...
- Page 7 Tips If you forget your service password, use the programming tool and PC with 2N® Service Tool. While entering the password, keep a timeout of 5 seconds (or any other value in the range between 1 and 9) for each character to avoid Lift1 hang-up and password/parameter re- entering.
- Page 8 Enter and 'p' for a 3-second memory 1 digits ® pause while programming via the 2N Lift1 Service Tool or using parameter 012–016 - ALARM up to 16 empty 017. (Refer to the full User Manual). button memories 2-6 digits 071 –...
- Page 9 872 – Message 0–30 s empty User announcement recording function, recording can be used for lift identification. 875 – Message 2 digits 1st digit = message that is repeated options after number dialing 2nd digit = message that is played after connection confirmation and call end The meanings of the digits are as follows:...
- Page 10 965 – Private mode 0–25 Incoming call permitted always during rescue process. Parameter specifies functionality when the rescue process is not active: 0 – incoming call permited during rescue process only. 1 – 24 – time after alarm, when incoming call is permitted (hours) 25 –...
-
Page 11: Technical Parameters
Hereby, 2N TELEKOMUNIKACE a.s., declares that the product is in compliance with the essential requirements and other relevant provisions of Directive Radio Equipment and Telecommunications Terminal Equipment Directive (R&TTE) 1999/5/EC. Declaration of conformity you can find on our website www.2n.cz. - Page 12 2N TELEKOMUNIKACE a.s. Modřanská 621, 143 01 Praha 4, Česká Republika Tel.: +420 261 301 111, fax: +420 261 301 999 E-mail: sales@2n.cz Web: www.2n.cz 2274v1.2...