Table of Contents
Advertisement
User Manual
GFK-2849A
Appendix A: ECM850 Command Line
The ECM850 supports a Command Line Interface (CLI) that allows you to monitor and
troubleshoot its operation. A computer can access the Command Line Interface using either
the module's Micro-B USB port or using Telnet over the IEC 61850 network. The ECM850's
CLI is identical in most respects to the RX3i PROFINET Controller's (IC695PNC001), for which
the PACSystems RX3i PROFINET Controller Command Line Interface Manual, GFK-2572 is
the primary reference. (Manuals can be downloaded from the Support website, referenced
in the Contact Information section at the front of this manual.) The command descriptions
provided there for the Global, Monitor access level & Modify access level commands are all
applicable to this module. The information in the remainder of this chapter will highlight
only those features of the ECM850's CLI that differ from the PROFINET Controller's CLI.
Note:
The prompt ecm>, appears on connecting a computer to the Command Line Interface.
The prompt appears in the Modify level (not in Configuration mode).
A-1
Monitor Level commands
The commands below are supported by the ECM850. The (†) indicates commands that are
added or modified for ECM850 support. Details of these ECM850-specific commands are
given in section A-3 ECM850 Commands, below
ECM850 Command Line Interface Support
Interface Support
Before attempting to connect to the module using the USB port, you must install the USB
driver as described in section 2.9 Installing the USB Port Driver.
alias
cls
help
history
log
login
node†
shconfig
show arp
show config
show debug exception
show debug fatalinfo
show icmp
show ip
show log
show mac
show mem
show network
show node
show port
show sntpstat†
show session timeout
show sm
show tcp
show telnetd
show time
show udp
terminate
Appendix A
Oct 2019
118
Advertisement
Table of Contents
