Table of Contents
Advertisement
Rotary Support to the Actuator.
Figure 5-7 Universal Rotary Mounting Kit
Installation, Operation, & Maintenance Manual
ES-09374-1
5.4.2
Installation of the Feedback Lever and Support
Figure 5-14 Installing the Feedback Lever and Support
3 - Mount the bracket to the positioner by placing the four M6x10 screws with lock
washers and plain washers. Tighten the screws with a 10 mm wrench.
Figure 5-8 Mounting the Bracket on the Positioner
ATTENTION
The positioner can be installed at any starting angle and operates in any position,
vertical or horizontal.
CAUTION
Be careful when handling compressed air hoses, make sure the line is disconnected
before connecting it to the positioner.
IMPORTANT
The positioner can be installed at any starting angle and operates in any position,
The feedback lever is graduated. Check the maximum valve travel for correct assembly of the
vertical or horizontal.
guide pin. Refer to Section 5.4.5 - Feedback Lever Types.
Mechanical Installation
22
Mechanical Installation
August 23, 2022
Mechanical Installation
13
Advertisement
Table of Contents
