Zepro ZHZ 500 Installation Instruction page 32

Powering up the tail lift
9 Powering up the tail lift
1. If applicable, ensure that the main switch is in the "Off" position.
2. If applicable, ensure that the cab switch (CS) is in the "Off" position.
3. When using a fuse box, connect the cable (1) to the battery's positive terminal and to the fuse box and
place the fuse (2) above, see Fig 36.
4. When connecting directly to the positive battery terminal, place the fuse (2) on the positive terminal, see Fig 36.
5. Connect the main power cable (3) to the fuse box / positive terminal, see Fig 36 - Fig 37.
6. Screw tight the cable connections and fuse with the knob (4). Install the cables at 90° or 180° from each
other. Install the fuse at right angles to the cables; see Fig 36 - Fig 37.
IMPORTANT!
The knob must bear against and centre the cable lug so that it does not come into contact with the screw.
Incorrect installation can cause the fuse to be ineffective. Risk of fire in the event of a short circuit.
7. Install the fuse box cover.
8. Where fitted, set the main switch to the ON position.
9. Where fitted, set the cab switch to the ON position.
Fig 36. Connection to the fuse box
Fig 38. Correct installation
32
4
3
2
1
Fig 39. Incorrect installation
Fig 37. Connection to the battery's positive terminal
ZHZ 500/600-850
4
3
2
Fig 40. Cover, fuse box
www.zepro.com