ADTRAN ISU 512e Manual page 22

Quick Start Guide
Press to exit to the status screen and verify READY condi-
Cancel
tions for each BRI line configured. If the status screen reads S
, TEI, or SPID, either the configurations of the switch proto-
D
OWN
col and SPIDs are incorrect or there may be a problem with the
ISDN line or translations (see Troubleshooting on page 8-1).
Service Profile/
Directory Number
SPID1/LDN1
SPID2/LDN2
SPID3/LDN3
SPID4/LDN4
SPID5/LDN5
SPID6/LDN6
SPID7/LDN7
SPID8/LDN8
To configure the ISU 512e using the VT 100 terminal interface, use the
following procedure:
1. Connect a VT 100 async terminal, or personal computer with a
terminal emulator running 9600 8-N-1, to the EIA232 MAINT
PORT.
2. Hold down the
Control
display the top level menu.
If the menu does not appear after performing step 2, ensure
that the correct COM port is selected on the computer and
functioning properly. Then try step 2 again.
3. Using the arrow keys and
the C
ONFIGURATION
Enter the SPIDs, LDNs, and Switch Protocol.
4. Use the left arrow or
When asked to save the ISDN parameters, type
5. Connect the ISDN lines.
Quick Start-2
Line Interface
Line 1
Line 2
Line 3
Line 4
key and press , and then press
R
key to navigate the menus, go to
Enter
/N O /D
ETWORK PTIONS IAL
key to go back up the menu tree.
Escape
ISU 512e User Manual
YNC
Maximum Bandwidth
128 kbps
256 kbps
384 kbps
512 kbps
to
Enter
L /ISDN menu.
INE
.
Y
61203086L1-1
,