ETC ColorSource Spot Installation Manual

ETC Installation Manual
®
ColorSource
Overview
The ColorSource Spot is an affordable profile fixture that offers the quality and support of an ETC LED
fixture. Utilizing an RGB-L color mixing system, the ColorSource Spot produces amazing color and
output for a four-color fixture. This light engine can be used with standard ETC shutter barrels, lens
tubes, Fresnel and Cyc Adapters, and accessories.
CAUTION:
Environment
The ColorSource Spot operates in ambient temperatures of 0°- 40°C and comes with a variable-speed,
quiet operation fan.
Note:
Note:
Electrical
WARNING:
• Operates between 100V and 240VAC at a frequency of 50/60Hz.
• Up to 9 luminaires (15A max) may be linked via power thru connector (10 luminaires total per
circuit) when used with an R20 relay module or Unison Echo Relay Panel. Consult breaker trip
curves when used with other equipment. Requires power from a non-dimmable source.
Installing a shutter barrel
The ColorSouce Spot can be purchased with or without a
shutter barrel. To install a shutter barrel you will need a #2
Phillips Screwdriver. (not provided)
The ColorSource light engine includes a barrel screw. The
small screw used to secure the top of the shutter barrel is
included with the shutter barrel.
Step 1:
Step 2:
Corporate Headquarters
London, UK

Rome, IT Tel +39 (06) 32 111 683

Holzkirchen, DE
Hong Kong

Web: www.etcconnect.com
7413M2100 Rev A

ColorSource Spot
Spot
• Risk of eye injury. Do not stare directly into the light.
• Do not operate in proximity to flammable materials.
The ColorSource Spot is for use in dry locations only.
• Maximum recommended ambient operating temperature: Ta = 40°C (104°F)
• Maximum anticipated external surface temperature at 40° ambient:
Tmax = 80°C (176°F)
• External temperatures after 5 minutes of full-brightness operation at 25°C (77°F)
ambient: 30°C (86°F)
• External Temperature (steady state achieved) at 25°C (77°F): 36°C (97°F)
Disconnect the fixture from power and DMX and allow it to cool before
performing any cleaning and maintenance.
Align the barrel to the front of the
ColorSource Spot and rotate it one quarter
turn counter-clockwise
Insert the shutter barrel into the front of the
light engine and rotate clockwise until it is
fully threaded onto the light engine.
Middleton, WI, USA
 
Tel +44 (0)20 8896 1000 Service: (UK)

Service: (UK) service@etceurope.com

Tel +49 (80 24) 47 00-0 Service: (DE)
 
Tel +852 2799 1220 Service: (Asia)

© 2015 ETC. All Rights Reserved.

Released 2015-05 ETC intends this document to be provided in its entirety.
 
Tel +608 831 4116 Service: (Americas)

service@etceurope.com
techserv-hoki@etcconnect.com
service@etcasia.com
Product information and specifications subject to change.

Page 1 of 4
Small screw included with the
shutter barrel
ColorSource Spot
light engine
service@etcconnect.com
Electronic Theatre Controls, Inc.