Barazza 1FEVGMC Instruction Manual page 27

unmounted glass panes could break and
cause injury.
Depending on the model, your oven may
have 1 or 3 panes of glass. Follow the
instructions for the type of door your oven
has.
1. Using your fingers, press the buttons
located at the top of both sides of the
oven door.
2. Keep them pressed and pull on the
plastic seal above the door.
3. Remove the glass panes from the door.
Clean them with a glass cleaner or soap
and water and a soft cloth.
WARNING! Pay attention to the order and
position of the
removing them
reassembled in the same order and
position when you have finished cleaning
them.
4. Once clean, insert pane no. 3 into the
same position so that the TERMOGLASS
indication printed on it is visible as shown
in following image.
glass panes when
as they must
5. Reattach the top seal of the door, making
sure that the side tabs fit into their
housings.
WARNING! Never switch the oven on if
any of the glass panes on the door are
missing.
Changing the oven light bulb
WARNING! Make sure the oven has been
disconnected from the mains before
changing the bulb.
The replacement
temperatures up to 300 ºC. You can order
them from the Technical Assistance Service
Department.
Changing the upper bulb
To substitute the light bulb, proceed as
follows:
1. Disconnect the oven from the power
supply. Take the plug out of the socket or
switch off the oven's power circuit.
2. Loose and remove the glass light cover.
be
3. Remove the bulb.
WARNING! The bulb may be very hot.
4. Fit a new G9 230V / 25W bulb.
WARNING! Do not touch the light bulb
surface directly with your fingers because
you may damage the bulb. Follow the lamp
manufacturer's instructions.
5. Tighten the glass light cover into place.
6. Connect the oven again to the power
supply.
27
bulb must withstand
EN