Installation And Binding Of External Devices; Binding Process - Landis+Gyr E470 User Manual

Page 20 of 69
5

Installation and Binding of External Devices

5.1

Binding Process

5.1.1 Binding and installation mode code entry
Action
Press and hold both push
buttons on the front of the
electricity meter until the
display shows:
The active number in the
code sequence is shown
as a flashing digit. To
increment the number
press the blue button, the
number will increase from
0 though to 9 then back to
0
To move to the next
number in the sequence,
press the orange button.
The sequence will move
one digit to the left and
the active digit shown
flashing. If an error is
made in entering a
© Landis+Gyr
Issue: 1.8
The installation process is in two parts; joining the metering components
together by a binding process and notification of the metering system to the
head End System. An automated notification process exists within the
meter however this may not be supported by the HES. Where the
automated process is not supported a manual method would be employed.
This section describes the automated process only.
The binding process is used to join devices to the electricity meter. Once
bound, the devices will ignore transmissions from any other meters within
the vicinity. The units will remain in this state until rebound.
During the process the devices exchange communication addresses and
security keys, logging serial number into the electricity meter. These serial
numbers are in turn displayed on the In-home display to provide
confirmation to the installer.
A remote process is available to prevent meters communicating when not
required (i.e. loss of gas supply contract).
Both binding and automatic installation processes use a 6 digit PIN to
instigate a particular process with the meter. The meter holds a record of 3
PIN's
£
C O D E
€
£
C O D E
€
£
C O D E
€
Installation and Binding of External Devices
Display
0 0 0 0
Pence/ kWh
1 0 0 0
Pence/ kWh
1 0 0 0 0
Pence/ kWh
E470 Tokenless Smart Prepayment Meter
Button Actions
Hold both buttons.
Press blue button
to increment the
number .
Press orange
button to move to
next digit.
Press and hold
orange button to
step backward to
previous digit