Purchase Code Entry - Landis+Gyr E470 User Manual

Page 56 of 69
9.8.17 Export Energy Register
9.8.18 Total Credit Register
9.9

Purchase Code Entry

© Landis+Gyr
Issue: 1.8
The export energy register displays the amount of energy measured in
reverse through the meter. The register will roll over to zero after 99999.99.
The export register will have the same 0,1 or 2 decimal place resolution as
the TOU energy registers.
£
E X P
€
The Total Credit Register displays the total value of purchased credit. See
section 5.3.
The Total Credit Register is displayed to 2 dp (whole pence/cents) without
leading zero's.
£
T P A Y
€
To enable the entry of various codes including installation, credit purchase
etc, the meter will allow the user to enter such a code using the two push
buttons fitted to the front of the meter.
The code entry sequence will operate the same for all types of code entry.
The code entry facility is entered using the Display Cycle (blue) and
Emergency credit (orange) buttons by pressing and holding both buttons for
2 seconds. While in the code entry mode normal button operation is
disabled.
When the facility has been entered the display will change from its normal
operating mode to display shown below.
£
C O D E
€
0 0 3 3 5 7 8
2 1 0 5 0
0 0 0 0
Meter Displays
Pence/ kWh
Pence/ kWh
Pence/ kWh
E470 Tokenless Smart Prepayment Meter