Installation - Landis+Gyr E470 User Manual

Meter Displays
9.10

Installation

9.10.1 MPAN Entry
E470 Tokenless Smart Prepayment Meter
Issue: 1.8
The flashing number is the active code digit, each press of the blue button
will increment the code digit from zero through to nine, rolling over to zero
again after nine is reached.
Each press and release of the orange button will move the code sequence
one place to the left. The previously entered digit will be shown to the left of
the active digit.
Once the expected code length has been reached the display will show
blank characters to denote the end of the sequence.
Holding the orange button for 1 second will move the sequence one place
to the right. The previous digit in the code will then become active and may
be changed by pressing the blue button.
The code may be moved forwards or backwards as many times as
required.
When all digits have been entered, pressing the orange button for a final
time will offer the code to the meter; the meter will either accept or reject
the code.
If the code is rejected the meter will state the error on the display:
£
C O D E
€
On entering an erroneous code, the meter allows the code to be re-entered
for up to 10 minutes. If a valid code is not entered after 10 minutes or if no
button presses are detected after 60 seconds the display will revert back to
the Default Operating display.
The meter will allow a maximum of 5 sets of code entries in a 24hr period.
Following the successful entry of the Service Code the meter display will
convert to an installation mode. The installation mode will allow the entry of
several parameters, MPAN or Customer number, Credit balance from old
meter, Arrears value from old meter, installers Authorisation Code. Details
are entered as follows:
The entry of the MPAN or Customer number will use the same process for
the entry purchase codes.
The code header will be changed as shown below:
E r r o r
Pence/ kWh
Page 57 of 69
© Landis+Gyr