Decommissioning - Landis+Gyr E470 User Manual

Page 24 of 69
Data Item
Arrears Register
Rate 1 kWh register
Rate 2 kWh register
Rate 3 kWh register
Rate 4 kWh register
Total kWh register
Export energy register
Meter Removal Code
Meter Exchange code
Meter Fitter Authorisation Code
5.2

Decommissioning

5.2.1 Meter Exchange
Data Item
Date and Time stamp
Electricity Meter Status flags2
Message ID
MPAN/Customer #
Meter Serial Number
Credit Mode
Emergency credit flags
Present Balance Register
Arrears Register
Rate 1 kWh register
Rate 2 kWh register
Rate 3 kWh register
© Landis+Gyr
Issue: 1.8
Returned in1
P
P
P
P
P
P
P
P
P
P
Return Data – Following the installation process the meter will be sent a full
configuration set of operation data including tariffs etc, from the utilities
information system. Additionally the meter may be sent Present balance
data and Arrears data if the meter is a replacement meter subject to an
exchange process.
Decommissioning of a meter is achieved by entering one of the two
decommissioning codes sent to the system at installation. NOTE: The
meter engineer would be instructed of the codes by use of the system.
The entry of the Decommissioning Codes is achieved using the using the
standard Purchase Code entry procedure - see display section. Once 6
digits have been entered the installer can offer the code to the meter by
pressing and holding both buttons for 2 seconds. If the code does not
match the either the removal code or exchange code held in memory, the
meter will show 'Error' and clear the entry. Lock out procedure will apply
according to the Purchase Code entry scheme.
When the meter exchange code is entered the meter will send a snapshot
of meter data to the system. The information will include:
Returned in1
H
H
P
P
P
P
P
P
P
P
P
P
Installation and Binding of External Devices
Details
Details
Message ID = EXCHANGE
Denotes credit or prepayment operating mode
Denotes emergency credit taken or not
E470 Tokenless Smart Prepayment Meter