Omron sysmac EtherNet/IP NJ Series Connection Manual page 29

4
Double-click I/O Map under
Configurations and Setup in
the Multiview Explorer.
5
The I/O Map Tab Page is
displayed in the Edit Pane.
Check that Node1 is displayed
in the Position Column and that
the added slave unit is displayed
in the Port Column.
*To manually set a variable
name for the slave unit, click an
entry cell in the Variable
Column and enter a name.
6
Right-click Node1 and select
Create Device Variable.
7
The variable names and types
are set.
Additional Information
The device variables are automatically named from a combination of the device names and
the port names.
The default device names are "E" followed by a serial number starting from "001".
For slave units with module configurations, the default device names are "M" followed by a
sequential number starting from "1".
Additional Information
In this guide, device variables are automatically named for each unit (each slave).
They can also be manually named for each port.
7．EtherCAT Connection Procedure
26