Abs, Abs/Abd 5.0 - SSANGYONG Musso Sports N100 2003 Manual

ABS, ABS/ABD 5.0

Initializing
1. Set the ignition switch n "ON" position.
2. Connect the No.1 terminal (Ground) and the No.13 (ABS)
from diagnosis socket located in E/G room by use of service
connector for 3 - 4 seconds and initialize the flash code.
Notice
Be careful not to connect over 5 seconds.
3. ABS indicator warning light continuously comes on until the
ignition switch is "OFF".
Dignosis Table
1. When the system is normal
One pulse (normal code 01) indicates.
l
2. When the system is abnormal
One pulse (defect code) indicates.
l
Notice
Repeat the initializing procedure when checking the
defect code Defect code is indicated once for 1 sec (light
on : 0.75 sec, light off : 0.25 sec).
Removal the Defect Code
1. Repair the defect code and remove the memorized defect
code in the ECU.
2. Connect the No. 13 terminal (ABS) from diagnosis socket
and No. 1 terminal (ground) for over 5 seconds.
3. Set the ignition switch in the "OFF" position.
Notice
Defect code will be memorized in ECU unless the defect
l
code is not removed.
Repeat the initializing procedure and check the other
l
defects.
ANTILOCK BRAKE SYSTEM 4F-11