Table of Contents
Advertisement
Air Bleeding
A. HOT MAX
B. COLD MAX
C. HOT MIN
D. COLD MIN
Normal
The air bleeding should be done after
servicing the power steering system and
when the difference between two
measurements (cooled and normal
temperature) is prominent.
A.
Lift up the vehicle very carefully.
B.
Turn the steering wheel to its both ends
several times and add the oil up to MAX
line in the steering oil reservoir.
C.
Periodically crank the starting motor and
turn the steering wheel to its both ends
without any interruption.
D.
Check the oil level again. If the oil level is
fluctuated, repeat the procedures from
step 3 to step 5.
E.
Start the engine.
F.
Turn the steering wheel to its both ends
until any bubble can be found in the
steering oil reservoir.
G.
Perform the test drive and check the
steering wheel for normal operation and
noise.
Abnormal
H.
If the oil level abruptly goes up, bleed the
air from the system again.
-
If the air bleeding is not properly
performed, the life span of the power
steering pump may be shortened.
4610-00
Advertisement
Table of Contents
