Table of Contents
Advertisement
A.
Pad Thickness
-
Measure the pad thickness and replace it if
it is below the wear limit.
New pad
10.5 mm
-
Wera limit point.
If a brake pad is worn beyond the wear
limit, replace both front brake pads.
B.
Disc Thickness
-
Measure the disc thickness at over ten
points.
-
If any of measured points is below the
wear limit, replace the brake disc with new
one.
New disc
28 mm
C.
Disc Run-Out
-
Install the dial gauge on the side of brake
disc and measure the run-out while
rotating the brake disc.
-
If the measured value exceeds the limit,
replace the brake disc with new one.
Otherwise, it may cause the pedal vibration
and shimmy when brakin
0.03 mm (before installation)
Limit
0.07 mm (when installed)
4850-01
Wear limit
2 mm
Wear limit
25.4 mm
Advertisement
Table of Contents
