Table of Contents
Advertisement
Push rod
Operating
rod lock nut
-
Check the pedal height with below
procedures:
A.
Stop lamp
switch
B.
Plunger
Specified value (A)
Remove the service mat before measuring
the pedal height.
-
Adjust the pedal height with below
procedures:
A.
B.
C.
D.
E.
F.
G.
H.
I.
J.
If the measurement is out of the specified
value, loosen the lock nut and adjust the
pedal height.
4850-01
Start the engine and measure the length
(A) between floor mat and pedal.
If the measured value is out of the
specified value, adjust the length.
Disconnect the stop lamp switch
connector.
Unscrew the lock nut and remove the
stop lamp switch assembly.
Loosen the lock nut on the pedal push
rod.
Turn the pedal push rod to adjust the
pedal height.
Tighten the lock nut.
Install the stop lamp switch assembly.
Connect the stop lamp switch connector.
Check if the stop lamps come on when
pressing the brake pedal around 5 mm.
If the stop lamp dpes not come on,
adjust the stop lamp switch assembly
again.
If the stop lamps come on, tighten the
lock nut and measure the pedal height
again.
179 mm
(from carpet)
Advertisement
Table of Contents
