Table of Contents
Advertisement
A.
Pad Thickness
-
Remove the front tire.
-
2. Measure the pad thickness and replace
it if it is below the wear limit.
New pad
10 mm
B.
Disc thickness
-
Measure the disc thickness at over ten
points.
-
If any of measured points is below the
wear limit, replace the brake disc with new
one.
New disc
5-link
10.4mm
Multi-link
20.0mm
C.
Disc Run-Out
-
Install the dial gauge on the side of brake
disc and measure the run-out while rotating
the brake disc.
-
If the measured value exceeds the limit,
replace the brake disc with new one.
Otherwise, it may cause the pedal vibration
and shimmy when braking.
0.03 mm (before installation)
Limit
0.07 mm (when installed)
4850-01
Wear limit
2 mm
Wear limit
8.5mm
18.4mm
Advertisement
Table of Contents
