Charging The Battery - Ingenico Link 2500 User Manual

Place the battery pack in its compartment.
Close the battery compartment trapdoor.

4.5.3 Charging the battery

When does the battery need to be charged?
/ On initial start-up, charge the battery for 4 hours under the
environmental conditions stated above
/ When used with a terminal power supply : connect the power
supply to Link/2500 USB C connector.
How does the battery need to be charged?
/ The environment in which the charge takes place influences
battery lifetime and autonomy (number of transactions)
The optimal conditions are as follows :
/ Charging away from any external heat source (radiator,
sun, enclosed area...)
/ The optimal temperature is between +15°C and +25°C
How can the battery be charged?
Using the terminal power supply
/ Connect the terminal power supply unit to the terminal type C
connector located on the right side of the terminal.
/ Connect the power supply unit to the power supply mains
network
/ Check to see if the battery symbol is flashing or moving(=battery
charging)
Link 2500 - Link 2500 I
900036315 R11 000 05/1022
Battery compartment
Copyright© 2022 Ingenico -
Banks and Acquirers
16
International Holding SAS
All rights reserved