Table of Contents
Advertisement
Battery
For safety reasons, the battery included with the terminal is not fully
charged. Please charge the battery before use.
When used daily, the terminal charges its battery each time the power
adapter is connected. Charging starts automatically.
In order to charge the battery:
Using the power adapter
Connect the power adapter to the terminal USB type-C
connector located on the left side of the terminal.
Connect the power adapter to the power supply mains
network.
When charging, a red charge light at the top of the screen will
display. This light will turn green when the terminal is fully
charged" (check that behavior!).
Check that the terminal is not connected to the main electric
network.
Power off terminal
Turn the terminal over and remove the battery door
Locate the battery pack connector beside the battery compartment
Plug the battery pack connector according to the connector locating
system.
AXIUM EX6000
07/11
Charging the battery
Installing the battery
14
Banks and Acquirers International Holding SAS
Copyright© 2023 Ingenico –
All rights reserved
Advertisement
Table of Contents
