Battery - Ingenico AXIUM DX6000 User Manual

WARNING
Switch off the terminal prior to installing a paper roll. Use only paper approved by Ingenico.
The use of no-approved paper is likely to damage the printer of your terminal.

4.5 Battery

4.5.1 Charging the battery
When does the battery need to be charged?
For safety reasons, the battery included with the terminal is not fully charged. Please charge the
battery before use.
When used daily, the terminal charges its battery each time the power adapter is connected.
Charging starts automatically.
How can the battery be charged?
Using the power adapter
Connect the power adapter to the terminal USB type-C connector located on the left side of the
terminal.
Connect the power adapter to the power supply mains network.
Check the charging status on the top of the screen (it means battery charging).
4.5.2 Installing the battery
WARNING
Check that the terminal is not connected to the main electric network.
Turn your terminal and unclip the battery door by pushing the clips as shown with the arrow on the
picture.
Disengage the battery door.
Take the battery pack included in the box.
Locate the battery pack connector beside the battery compartment.
Plug the battery pack connector according to the connector locating system.
Place the battery pack in its compartment.
Close the battery door.
AXIUM DX6000
02/21
17
Banks and Acquirers International Holding SAS
Copyright©2024 Ingenico–
All rights reserved