Table of Contents
Advertisement
QUICK REFERENCE GUIDE
PAGE TO OTHER CONTROLLERS:
use this feature to access all Multizone Controllers addressed on the network.
You can then modify or adjust lighting levels previously programmed.
• Press the Page Zones button to access the desired Controller (refer to
Figure 4).
• If access is not allowed to other Multizone Controllers, refer to the Setup
Wizard, Step 15 to include remote panels on the network.
CHANGE CONFIGURATIONS:
configurations, use this feature when changing the partition setup in a room.
NOTE: If partitioning has not been setup yet, follow the SETUP WIZARD to
program the Panels section before proceeding.
• Press the Wizards button and then the Up or Down
button to select the Config Wizard. Press the Select/
Next button to access the CONFIG WIZARD.
• Press the Select/Next button to access the Set Config
screen.
• Press the Up or Down buttons to select the desired
Configuration (001-256).
• Press the Select/Next button to save entry and return
to the CONFIG WIZARD screen.
• Press the Wizards button to return to the Main
Screen.
6
DI-000-D3208-00A-2/13/02
If using multiple Multizone Controllers,
If using multiple Multizone Controller
8
V
Use , v or SEL
<CONFIG WIZARD>
V
Use
, v or SEL
>Set Config
CONFIG 001
SELECT: 001
V
Use , v or SEL
<CONFIG WIZARD>
3/6/02, 11:04 AM
Advertisement
Table of Contents
