µ-Dimension D3208 User Manual page 29

8. Press the Up or Down buttons to select the Lock/
Unlock screen.
9. Press the Select/Next button to access the Lock/
Unlock screen.
10. Press the Left or Right buttons to select the Panel
and the Up or Down buttons to select the desired
Zone (1-8) to lock or unlock.
NOTE: If a zone is locked, press the Select/Next
button to unlock
11. Repeat procedure for programming of additional
zones.
12. The ZONE WIZARD is now finished.
13. Press the Wizards button to return the Main Screen.
IR WIZARD –
The IR WIZARD allows for the programming and remote
A
control of up to 8 lighting scenes using a Leviton IR Remote, Cat. No. NE210
or 32 lighting scenes using any standard IR Remote as well as MAX, OFF and
GROUP DIM/BRIGHT.
NOTE: No matter what IR Remote is used, each IR code must still be
programmed individually.
NOTE: To change an existing IR code, you must first remove that code and
reprogram.
1. Press the Wizards button and then the Up or Down
button to select the IR WIZARD. Press the Select/
Next button to access the IR WIZARD.
2. Press the Select/Next button to access the Learn IR
screen. This setting is used to setup the
programming commands for desired scenes.
3. Press the Up or Down button to select the desired
Action (SCENE 01-32, DIM, BRIGHT, OFF, MAX,
REMOVE ALL). Press the Select/Next button to
save entry and proceed.
4. Point the IR Remote at the Multizone Controller and
press the button you wish to teach the command.
5. Press the selected button again to verify programming.
6. Press the Select/Next button to save entry and proceed.
7. Repeat procedure for additional command learning.
8. IR learning is now finished.
DI-000-D3208-00A-2/13/02
PROGRAMMING AND OPERATION
29
V
Use , v or SEL
>Lock/Unlock
PANEL: 01 ZONE:1
ZONE # 01-1
Zone # 01-1
Local: 1 Unlock?
Zone Unlocked!
SEL to Continue
V
Use , v or SEL
<IR WIZARD>
V
Use , v or SEL
> Learn IR
Select Action:
<SCENE 01>
Press IR Button
Code: 0000 C:000
3/6/02, 11:05 AM
27