µ-Dimension D3208 User Manual page 38

TROUBLESHOOTING
the box is one group. If your installation does incorporate partitioning, you should
perform this test AS LONG AS you have programmed a configuration which links
all D3208's together in one group.
1. First make sure the system is in the configuration where all attached devices
are in a single group. (This will automatically be the case if your installation
is not accommodating combine/separate functionality for partitions.)
2. Press a scene button and make sure that the other D3208's go to that same
scene. The same scene button should light up on each unit. If this works as
expected, the D3208 HAS PASSED THE TEST.
If they are not behaving as a single unit:
• Press the scene button again and check to see if the scene is locked. If it
reads "LOCKED," unlock it via the Scene Lock screen within the Scene
Wizard.
• Press each active Zone Info button to check to see if any zones are
locked. If any are locked, unlock them via the Lock/Unlock screen in the
Zone Wizard.
• Check the LCnet Wiring Diagram.
Remote D3208 Access:
If you have programmed any of the D3208's to remotely control the loads
attached to other D3208's on the same LCnet you should test that this is
functioning properly. Run through this test for any D3208 that you have
programmed for remote access to other Zone Controllers.
Go to each controller you have programmed for remote access and:
1. Press the Page Zones button and select the first panel for remote access. As
soon the panel number is "selected" you should notice that the zone LED's
shift from displaying their local zones to the zone information and light levels
of the loads attached to the remote D3208 just selected.
2. Press group dim or brighten to verify that the lights wired to the correct
remote panel actually dim or brighten. If they do not.
• Reprogram the D3208 you are at using the Setup Wizard.
• If this does not work, check the LCnet Wiring Diagram.
36
DI-000-D3208-00A-2/13/02 38 3/6/02, 11:05 AM