µ-Dimension D3208 User Manual page 25

SCENE WIZARD –
operation of up to 32 lighting scenes. Naming of device and lighting scenes
gives user-friendly control of lighting loads. Proceed as follows:
Call Scene –
B Used to choose which of the 32 programmed scenes are to be
called or activated. Proceed as follows:
NOTE: Pressing a SCENE button (refer to Figure 4) will also call or activate
a programmed scene. In addition, pressing the function button will toggle
though the Scene Banks (01-08, 09-16...25-32) and then pressing a SCENE
button will activate that bank.
Scenes 01-08 for group 1 will have the following preset levels
preprogrammed with all 6 physical loads being programmed to the same
levels (factory set default):
Scene 1 10%
Scene 2 25%
Scene 3 40%
Scene 4 55%
1. Press the Wizards button and then the Up or Down
button (if necessary) to select the SCENE WIZARD.
Press the Select/Next button to access the SCENE
WIZARD.
2. Press the Select/Next button to access the Call
Scene screen.
3. Press the Up or Down button to select the desired
scene to call (01-32). Press the Select/Next button
to save entry and proceed.
4. Press the Up or Down button to call the a scene
with a desired fade time (default, 0:00 seconds to
2h00m). Press the Select/Next button to save entry
and proceed.
NOTE: This fade time is different from the fade time programmed in the
scene.
5. Press the Select/Next button to Execute Scene screen.
Program Scene –
B
desired scenes. Proceed as follows:
NOTE: Scene programing can also be accessed by holding down a SCENE
button for 8 seconds and then proceeding.
1. Press the Wizards button and then the Up or Down
button (if necessary) to select the SCENE WIZARD.
Press the Select/Next button to access the SCENE
WIZARD.
DI-000-D3208-00A-2/13/02
PROGRAMMING AND OPERATION
The SCENE WIZARD allows for the programming and
Scene 5 75%
Scene 6 90%
Scene 7 55%
Scene 8 25%
Used to program, name and set fade-transition rates to
25
V
Use , v or SEL
<SCENE WIZARD>
V
Use , v or SEL
> Call Scene
Select scene: 01
Scene 01
SCENE 01
Set Fade: <def>
V
Use , v or SEL
<SCENE WIZARD>
3/6/02, 11:05 AM
23