µ-Dimension D3208 User Manual page 24

PROGRAMMING AND OPERATION
29. Press the Up or Down button to select the Aux
Address screen.
30. Press the Select/Next button to access the Aux Address screen.
31. Press the Up or Down button to select the desired
PANEL (01-31) and the Left or Right buttons to
select the desired ZONE (1-8).
32. Press the Select/Next button to SET AUX DEVICE Address.
33. Press the Select/Next button to continue.
34. The SETUP WIZARD is now finished.
System – Used for factory representative field use only.
A
CLOCK WIZARD –
B
section is the next step in using this device. It provides basic Time and
Daylight Savings settings. Proceed as follows:
NOTE: If multiple Multizone Controllers are installed on the LCnet, all units will
synchronize when settings are stored from the Multizone Controller being
programmed.
1. Press the Wizards button and then the Up or Down
button to select the CLOCK WIZARD. Press the
Select/Next button to access the CLOCK WIZARD .
2. Press the Select/Next button to access the Set
Date-Time screen.
3. Press the Select/Next button to access the Adjust
Time screen.
4. Enter the time by pressing the Up or Down and
Left or Right buttons. Press the Select/Next button to save entry and
proceed.
5. Enter the date by pressing the Up or Down and
Left or Right buttons. Press the Select/Next button to
save entry and proceed.
6. For Daylight Savings, press the Up or Down buttons
to toggle between ON and OFF. Set to ON position if
Daylight Savings is observed in your area. Set to the
OFF position to disable setting.
7. Press the Cancel/Previous button to complete CLOCK WIZARD
programming and return to the Main Screen.
22
DI-000-D3208-00A-2/13/02
Accessing and properly selecting the settings in this
24
V
Use , v or SEL
4> Aux Address
PANEL: 31 ZONE:7
ZONE # 31-1
V
Use , v or SEL
<CLOCK WIZARD>
V
Use , v or SEL
> Set Date-Time
Adjust Time:
12:00:00 AM
Adjust Date:
01/01/02 Tu
Daylight Saving
Auto adjust<ON>
3/6/02, 11:05 AM