Table of Contents
Advertisement
Safety
Introduction
Preparing for the Install
Consider the information below before you begin installing the foam system.
• Determine the install location for the components, consider wire and hose
routing, mounting locations and maintenance requirements.
• Locate the pump as close to the supply source as possible. Install it in a
clean space where it can be easily inspected and maintained. Allow room for
checking the oil level, changing the oil and general servicing.
• Do not remove the components from the bracket and install them directly to
the apparatus. Doing so will void your warranty.
• Position the pump assembly in an area that is protected from road debris and
excessive heat buildup.
• Be aware that most water tank manufacturers incorporate a foam tank into
the booster tank.
• When specifying an integrated foam tank, ensure that you include the
installation of the optional low tank level sensor as well as the foam suction
connections and tank drainage according to NFPA guidelines.
• Determine a location for the OIT on the operator panel of the equipment.
Product Overview
Installation
Operation
Installing the Vented Oil Cap
NOTICE
Before operating the
AQUIS™ Foam
Proportioning System:
• Check the foam pump oil level
and fill if necessary.
• Remove the foam pump
shipping plug and replace it
with the vented oil cap.
The foam system ships with a non-vented oil cap. Replace it with the
vented oil cap that is provided before you operate the pump.
1. Locate and remove the oil cap that was shipped with the pump
(Figure 1, Figure 2
and
2. Check the oil level. Refer to:
3. Add oil if necessary. Refer to:
4. Install the vented oil cap that is supplied with the pump kit
(Figure 1, Figure 2
and
|
36
64
Maintenance
Troubleshooting
Refer to instruction
F-1031-2447 for
detailed information.
Figure
4).
"Checking the Oil Level" on page
"Adding Oil" on page 59.
Figure
4).
58.
Advertisement
Table of Contents
