Component Overview; Hose Lines And Fittings; Supply Hose; Inject Hose - Waterous AQUIS 1.5 Installation, Operation And Maintenance Instructions

Table of Contents

Advertisement

Safety
Introduction

Component Overview

The AQUIS foam proportioning system injects a foam concentrate into the
waterway to create a solution that is delivered to the apparatus discharge lines.
The AQUIS system consists of many components that control and distribute the
concentrate. This section describes the components, appropriate specification,
and how they are used in the system.

Hose Lines and Fittings

Hose lines distribute the concentrate between the foam system components.
Hoses are not supplied in this kit. Contact Waterous for more information.

Supply Hose

The supply hose routes the concentrate from the supply tank to pump.
Contact Waterous for information about obtaining hose lines or you can
source them locally.

Inject Hose

The inject hose routes the concentrate from the pump to the injector.

Fittings

Fittings connect the hoses to the various components in the system.

Bypass Hose

The bypass hose routes the concentrate from the inject/bypass valve to
outside the apparatus.

Pump Mounting Hardware

The mounting hardware is required to secure the pump assembly to the
apparatus. The hardware is not supplied with the kit. Source the hardware
locally.

Power Cables

Power cables bring power to the pump. Make sure that you use the same
length and gauge for both the positive and the ground cable. The cables are
not supplied in this kit. Source power cables from a local supplier. Refer to
"Connecting the Power Supply" on page 42
Product Overview
Installation
for specific requirements.
Operation

Concentrate Tank

The concentrate tank holds the concentrate until it is required.

OIT/HMI Cable

This cable connects the OIT or HMI to the control box
This cable is an M12, 8-pin connector.

Flowmeter Cable

This cable connects the flowmeter to the control box
This cable is an M12, 5-pin connector.

Cable Extension

Extension cables extend the routing distance of the flowmeter or OIT/HMI
cable. Contact Waterous for information about obtaining extension cables.
Cables are available in a 3 and 6 meter lengths.
|
26
64
Maintenance
Troubleshooting
(Figure 3
(Figure 3
and
Figure
5).
and
Figure
5).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aquis 3.0Aquis 6.0

Table of Contents