Safety
Introduction
Installation Overview
This equipment is intended to be installed by a person or persons with the basic
knowledge of installing similar equipment. Contact Waterous with questions
about installing the equipment. The installation may require the following tasks
and abilities:
• Locating, drilling, and cutting
features into the apparatus.
• Installing and securing plumbing.
Preparing for the Installation
Use the following guidelines before, during, and after the installation.
• Read and understand all the installation instructions before installing the
equipment.
• Prepare a suitable, well-lit area, and gather all the necessary tools before you
begin the installation.
• Make sure that you remove any shipping plugs or caps before installing the
component.
• Make sure that you bring all fluids to operating levels before using the
equipment.
NOTICE
Before Operation
• Read and understand all
the instructions provided.
• Check all fluid levels
and replenish if necessary.
• Remove all shipping plugs
and install the operation
plugs or caps.
Product Overview
• Routing and securing the wiring.
• Calibration and final testing.
Installation
Modifying the Equipment
This equipment is intended to operate as designed. Do not remove, modify, or
change the components in the system. Doing so will void the warranty.
NOTICE
Modification
Modifying the equipment
•
can damage components
and void your warranty.
Do not modify the system
•
or any of its components.
Do not modify the system or any components. Doing so will void your
warranty.
Determining the Pump Location
Use the following guidelines to determine a location to install the pump:
• Consider how the location influences the drive-shaft alignment.
• Consider hose and cable routing.
• Consider accessibility for operation and maintenance.
• Install the pump where it has minimal exposure to excessive dirt, road debris,
and heat buildup.
Determining Cable and Wire Routing
Use the Wiring Best Practices document, available at www.waterousco.com, as
a guide to select and route wiring for your application.
|
25
46
Operation
Maintenance