Table of Contents
Advertisement
1.
Install bearing in case bore. Bearing is to be flush with face of case flange.
2.
Lay the transmission case on its side with the pump flange facing up.
3.
Reaching through the opening in the case, set the spacer and then the driven sprocket on the bearing installed in step one. Note that the chamfer on the spacer must face towards
the bearing.
Driven Sprocket
Bearing
F-1031, Section 4319
Reassembly - Install Drive Shaft
Installing Bearing in Case
Spacer,
.826 in. (20.98 mm) Wide
Pump Mounting Flange
Page 19 of 32
Advertisement
Table of Contents
